Pages

Tuesday, August 16, 2016

Ratty Port Replacement

This post originally appeared on Windborne in Puget Sound

One of two failing ratty fixed ports

Last summer while doing gelcoat repair, I mentioned that the ratty fixed ports on Eolian's aft-facing cabin house were long overdue for replacement. Well, now is that time.

Even Plexiglas eventually falls prey to the relentless UV from the sun, tho it lasts far, far longer than Lexan - this port is 38 years old.  If it had been polycarbonate, it would have looked much worse after only 5 years.

Tho there are no leaks (yet!), the bedding is overdue for replacement, as well as the port.
Removing the port was easy.  Back out the screws on the inside, and then push it out.  No, that bedding was definitely NOT firmly holding the port in place.  Tho it was clearly not leaking, there appeared to be no reason for that except for habit.

The next problem was that the new port is a little larger than the old one (well, I guess that's better than the reverse...).  First I taped over the entire area with some white duct tape I had on board to protect it from the vibrating sabersaw table.  Then I used the outer trim ring of the new port as a stencil, and marked a cut line.  My trusty (but crummy - I gotta get a better one) saber saw with a grit-edge blade cut thru the 1" thick sandwich of fiberglass, foam, fiberglass with relative ease.  To constrain the mess, Jane was  inside with a shop vac positioned to catch the dust and chips.

(Note to self:  Next time, just tape some plastic over the inside and clean up afterwards - that will be more effective and easier.)


The new opening port is a little larger than the old one.
Before the final installation, one more step was necessary.  Because we often sit on the back deck and lean against the bulkhead that has this port (and a second one, which will also get replaced), it was necessary to trim the spigot to a minimum projection - for comfort.  So I installed the port, held the trim ring in place, and traced around the projecting spigot with a ballpoint pen.

Then I removed the port and laboriously cut off the extra spigot length with a hand hacksaw (the same one I used to cut the exhaust hose...).  I preferred to use a hand tool for this job because, tho it cut slowly...  it cut at a speed that permitted me to maintain a uniform 1/8" from the pen marking.  After cutting, I used a fine file to smooth off the saw cut markings, and break the resulting sharp edges slightly.


Trimmed and ready for final caulking
Before final installation, I carefully sealed the exposed foam core in the opening with the same silicone that Beckson requires for bedding the port*.  If there was any leakage in the future, I didn't want it to get into the core.  Then I injected silicone into the gap between the port and the deckhouse, and smeared a little on the back side of the trim ring.  Press the trim ring into place, some clean up, and it is done!

Now, one more to go, and then all the fixed and opening ports on the boat will have been replaced, giving us a total of 11 opening ports.


* I hate the use of silicone on a boat, but this is one of the few places that I will use it.  In this case, it is because Beckson specifies it.

No comments:

Post a Comment