Rare is the boat project that can be completed in a single afternoon.
Pilgrim's tired, teak drop boards. Pilgrim arrived in Beaufort with three teak companionway drop boards. The existing teak drop boards are both too thin, between ½” and 5/8”, and too short. Due to the inadequate size, the boards would bind up unless extreme caution was employed when removing or installing them.
The solution? Two new ¾” thick King Starboard drop boards. Since the Starboard does not require painting or varnishing, the project fit neatly into a couple hours…
- Lay out the proper dimensions.
- Rough cut the Starboard with a circular saw.
- Using a router, create a rabbit joint between the upper and lower boards. Set up the joint to shunt water outside the boat.
- Using flush trim and round over bits in the router, finish the edges of the boards.
- Install the hasp.
Pilgrim's new Starboard drop boards. The new boards slide easily in and out of position. Unlike the top of the slider or the exterior companionway step pictured above, the new drop boards will never require refinishing.
We plan to replace all the exterior teak in the image above… in due time.
Life aboard is living large, in a small space. Every boat owner has found ways to make life in that small space easier, more comfortable, more convenient. The idea behind this site is to provide a place where these ideas can be shared amongst the boating community. To participate, send your contribution to SmallBoatProjects at gmail dot com.
Pages
▼
Tuesday, November 10, 2015
New Companionway Drop Boards
Jeff and Anne on s/v Pilgrim take on a small project that many, many boats need:
No comments:
Post a Comment