Pages

Tuesday, December 11, 2012

Making Baggywrinkle

In addition to its time-proven effectiveness at preventing chafe, there isn't a much better way to make your boat look "salty" than to install some baggywrinkle. And Steve and Lulu on s/v Siempre Sabado show us how easy it is to make:

HerveFirst off, the basic instructions came from one of our favorite books: “The Arts of the Sailor” by Hervey Garrett Smith.


You can also find the directions (including Hervey’s) on-line by googling “making baggywrinkle”.  But, it’s a lot more fun to have a copy of Hervey’s book onboard.

First you have to collect a whole bunch of 5-6″ pieces of line that’s not good for much of anything else.  We used the cut-off ends of the 3/4″ manila that we made our fenders out of.  Lulu unlayed the line and then divided each strand into separate yarns.

Then you double a long piece of nylon line to use as a core and fasten it between two anchors.  To get an idea of how long the core needs to be, a 4′ long piece of baggywrinkle, wrapped around a 1/4″ shroud, will end up about 1′ long.

Now you need to start making the individual thrums or rovings.  Pass the yarn under the core piece:

Step 1
Step 1

Then, bring the ends up around the outsides and pass then down between the core pieces:

Step 2, such as it is.

Pass the ends around the outside of the core and down through the middle.
And then push it up against the pieces you’ve already done:

All snugged up.
All snugged up.

Once the baggywrinkle is as long as you want, just tie the ends of the core piece together but leave it long for tying on to the shrouds.

making baggywrinkle

Then, you just tie one end on to the shroud and wrap the baggywrinkle around and around until you end up with a “brush”.  Tie off the ends.  Secure the knot with rigging tape if you’re insecure about the security of your knotwork, and then stand back and wait for everyone to ask, “Where’d you get those?”

tie it on

There you have it.

No comments:

Post a Comment